Reviewer:
Derek McFarlin from Spring, TX United States
The look and finish are nice, but install instructions could have easily been provided, as opposed to the shotrtcut insruction to refer to the user manual. For the record, just remove the trigger pack, the bolt and carrier, and then make sure that the raised area of the inner plate is facing you.
Was this review helpful to you?
0 of 0 people found the following review helpful:
tavor ejection port cover
February 17, 2015
Reviewer:
Alain Mendoza from Reno, NV United States
Nicely machined. An improvement to the factory part. Stops gases from powdering your face.
Was this review helpful to you?
0 of 0 people found the following review helpful:
Tavor ejection port cover
February 4, 2015
Reviewer:
John Reed from Norwalk, CA United States
Well made part for an expensive gun. Reasonable price.
Was this review helpful to you?
0 of 0 people found the following review helpful:
No more fart face!!
January 21, 2015
Reviewer:
Jeff Kemp from Hudson, FL United States
Not that I run my weapon suppressed or put more than 200 rounds downrange at a time. But the gas does become a little nauseating after a couple hundred rounds. This seems to take care of most of the gas blow by that you get from the stock to Ejection port cover.
Was this review helpful to you?
0 of 0 people found the following review helpful:
Works well
January 7, 2015
Reviewer:
Kenneth Kirsh from Lexington, KY United States
Wanted to avoid any gassing issues and this is nicely made.
Very Nice But Directions Would be Even Better 
