FLEx stands for Fulcrum Located Extra swivel. It provides a centralized location for use with a single point sling or just an additional swivel location for a 2 point. And it's ambidextrous! The GHW's AUG FLEx cleverly replaces the factory take down slide and gives you a limited rotation QD socket. It balances the rifle perfectly for a single point sling but also works great as the front location in a two point setup, from either side of the rifle.

Made in the USA!

FLEx stands for Fulcrum Located Extra swivel. It provides a centralized location for use with a single point sling or just an additional swivel location for a 2 point. It can be mounted on either side of a Tavor or X95, with the swivel towards the front or rear of the rifle, replacing the plastic factory port cover. But its greatest feature may be that it also seals off the port from escaping gases that tend to leak out of the factory port cover. This phenomenon has become known as "Tavor face" and leaves you with black smudges on your cheek and shooting glasses, and is exacerbated with suppressor use. The GHW FLEx is truly a must have if you are running a suppressor on your Tavor or X95!

Made in the USA!

While 2-point slings are ideal for most situations, there are times when a 1-point sling has a clear advantage. Combining the polymer Burnsed Socket and patented RED Swivel, the Vickers 221 Sling allows users to switch from 2-point to 1-point mode instantly by pulling on the RED Swivel knob and reinserting it in to the Burnsed Socket at the rear of the receiver. The instantaneous adjust-ability of the sling is still maintained in both 1 and 2 point modes.

The 221™ Sling fits any weapon with two QD sling swivel sockets.

The padded, 221 VCAS is available in Black or Coyote Brown.

The RSA QD provides a sling attachment point for the MS4 and other QD sling systems • Steel construction • Melonite finish • Compatible with 1913 Picatinny rails

The MS4 can quickly switch between one-point and two-point configuration. The MS4 maintains material construction and specifications identical to that of the standard MS3, but features two heavy-duty push-button QD sling swivels rather than the Magpul Paraclip™ aling with a steel D-Ring to allow one to two-point convertibility. This modification allows compatibility with QD sling cups commonly found on lower receivers, receiver end plates, buttstocks, and many low-profile forward QD Sling mounts, including the Magpul RSA-QD.

The MS4 Dual QD GEN 2 incorporates a new low profile quick-adjust Slider which minimizes bulk and allows for secure, yet effortless, sling adjustment. Webbing length has also been increased for a comfortable fit with all body types and armor configurations.

• All cast steel construction • Mil-spec black manganese phosphate finish • Works on any standard 1913 Picatinny-spec rail

Filling the same mission requirement as the standard MS3 Sling, the MS3 Single QD can quickly switch between one-point and two-point configuration. The MS3 Single QD maintains material construction and specifications identical to that of the standard MS3, but features a heavy-duty push-button QD sling swivel for the one-point (rear) weapon attachment rather than the Magpul Paraclip™. This modification allows compatibility with QD sling cups commonly found on lower receivers, receiver end plates, and buttstocks. The MS3 Single QD GEN 2 incorporates a new low profile quick-adjust Slider which minimizes bulk and allows for secure, yet effortless, sling adjustment. Webbing length has also been increased for a comfortable fit with all body types and armor configurations.